Cristian Bradiceanu

fpu – Onboard FPU
vme – Virtual Mode Extensions
de – Debugging Extensions
pse – Page Size Extensions
tsc – Time Stamp Counter
msr – Model-Specific Registers
pae – Physical Address Extensions
mce – Machine Check Architecture
cx8 – CMPXCHG8 instruction
apic – Onboard APIC
sep – SYSENTER/SYSEXIT
mtrr – Memory Type Range Registers
pge – Page Global Enable
mca – Machine Check Architecture
cmov – CMOV instructions (plus FCMOVcc, FCOMI with FPU)
pat – Page Attribute Table
pse36 – 36-bit PSEs
pn – Processor serial number
clflush – CLFLUSH instruction
dts – Debug Store
acpi – ACPI via MSR
mmx – Multimedia Extensions
fxsr – FXSAVE/FXRSTOR, CR4.OSFXSR
sse – SSE
sse2 – SSE2
ss – CPU self snoop
ht – Hyper-Threading
tm – Automatic clock control
ia64 – IA-64 processor
pbe – Pending Break Enable

syscall – SYSCALL/SYSRET
mp – MP Capable
nx – Execute Disable
mmxext – AMD MMX extensions
fxsr_opt – FXSAVE/FXRSTOR optimizations
pdpe1gb – GB pages
rdtscp – RDTSCP
lm – Long Mode (x86-64)
3dnowext – AMD 3DNow! extensions
3dnow – 3DNow!
k8 – Opteron, Athlon64
k7 – Athlon
constant_tsc – TSC ticks at a constant rate
up – smp kernel running on up
pebs – Precise-Event Based Sampling
bts – Branch Trace Store
nonstop_tsc – TSC does not stop in C states
pni – SSE-3
pclmulqdq – PCLMULQDQ instruction
dtes64 – 64-bit Debug Store
monitor – Monitor/Mwait support
ds_cpl – CPL Qual. Debug Store
vmx – Hardware virtualization
smx – Safer mode
est – Enhanced SpeedStep
tm2 – Thermal Monitor 2
ssse3 – Supplemental SSE-3
cid – Context ID
fma – Fused multiply-add
cx16 – CMPXCHG16B
xptr – Send Task Priority Messages
pdcm – Performance Capabilities
dca – Direct Cache Access
sse4_1 – SSE-4.1
sse4_2 – SSE-4.2
x2apic – x2APIC
aes – AES instructions
xsave – XSAVE/XRSTOR/XSETBV/XGETBV
avx – Advanced Vector Extensions
hypervisor – Running on a hypervisor
lahf_lm – LAHF/SAHF in long mode
cmp_legacy – If yes HyperThreading not valid
svm – Secure virtual machine
extapic – Extended APIC space
cr8legacy – CR8 in 32-bit mode
abm – Advanced bit manipulation
sse4a – SSE-4A
ibs – Instruction Based Sampling
sse5 – SSE-5
skinit – SKINIT/STGI instructions
wdt – Watchdog timer

Internet service in Egypt, the UAE, India and other counties in the region was interrupted today when submarine cables in the Mediterranean Sea failed. 

Cause of the failure is not known at this time, says operator Reliance GlobalCom. A total of three cables linking Italy and Egypt went down. A ship has been sent out to fix the problems.

Currently, services are being rerouted to backup cables and satellites. As rerouting measures fully kick in, services are expected to improve by early Saturday morning.

This isn’t the first time that cable service to the region has failed. Earlier this year, five separate undersea cables were cut between late January and early February, interrupting service to a number of countries.  

There’s likely to be some serious failure analysis involved if we see some more pipes go off-line in the next week.

(quoted from here).

SANS Internet Storm Center page about this event.

Enable ipv4 forwarding:

routeadm -u -e ipv4-forwarding

Configure NAT in /etc/ipf/ipnat.conf (replace e1000g0 with your outside interface, 172.16.0.0/12 with your LAN IP range):

map e1000g0 172.16.0.0/12 -> 0/32 proxy port ftp ftp/tcp
map e1000g0 172.16.0.0/12 -> 0/32 portmap tcp/udp auto
map e1000g0 172.16.0.0/12 -> 0/32

Enable ipf:

svcadm enable network/ipfilter

Starting this morning the Internet link is very slow, with 10-40% packet loss and 1.5 second RTT. This could be due to Qtel’s PCCWBTN link down starting after 8 a.m. AST. Traffic is routed via AS6453 (Teleglobe), which is heavily overloaded and oversubscribed. Of course, the FLAG Telecom link is not used for ADSL subscribers. So, the 2 MBPS ADSL link (largest residential package available in Qatar) real speed is around 200 kbps. This reminds me of home Internet access ten years ago.

http://en.wikipedia.org/wiki/2008_submarine_cable_disruption

Two separate oceanic cable systems in the far East were severed around 0800 hrs GMT on January 30 2008, greatly impacting both Internet and voice traffic to the region. A third cable was cut at 0559 hrs GMT on February 1 2008.

http://www.dailywireless.org/2008/01/30/oceanic-fiber-cut/

Just upgraded my Mac mini I use as a media center to find out that the new Front Row does not stream to remote AirTunes speakers as it did in Mac OS X 10.4 Tiger. Front Row sound goes only to audio out, which is connected to the TV. One more thing: the music stops when leaving the Music menu in Front Row. Mac OS X 10.5.1 update does not fix these problems. Apple Support Discussions thread is here.

“YouTube not available” error message is shown on the iPod touch display when a proxy server is configured.

I see a 404 error message for http://iphone-wu.apple.com/feeds/standardfeeds/ in squid logs.

Same problem reported on Apple Discussions.

Thanks to Sling Media, I can watch all cable and Pay-TV stations in Qatar, streamed directly from my home over the Internet. I can even remote control the Set-Top Box.

Sling Box (classic) connections: analog antenna (tuner) – cable, Composite input – UPC STB. The setup will be complete with a DVD HDD recorder (connected to S-Video input and also to the STB).

The new Sling Box Pro is on the way from amazon.co.uk.